Download FOR: 2008 + Audi A4. PLEASE READ ALL INSTRUCTIONS BEFORE BEGINNING INSTALLATION 1. LOCATION ( See Diagram below ): Using masking tape, run the tape as seen in Diagram below from POINT A to POINT B. Press tape against the vehicle, making sure that the tape is straight from POINT A to POINT B. 2. CLEAN AND PREP : For proper installation of Custom Body Side Molding, clean the surface where the molding is to be installed using the alcohol pads enclosed. Wipe off excess residue with a clean cloth. Apply PRO- BOND ADHESIVE PROMOTOR in the crush swab self-applicator. Squeeze the applicator until you feel the applicator “crush”. The applicator will become wet on the end and is ready for use. Quickly apply a thin coat of PRO-BOND below the masking tape line, no further than 1 ¼” below the tape. Be careful not to go lower than 1 ¼” because PRO-BOND could dull the paint surface. The light coat of PRO-BOND will dry quickly. Where cooler temperatures prevail, make sure the molding is at room temperature. The recommended metal surface temperature of the vehicle should be at least 75°F/24°C for proper installation. If the surface is cold, use a heat gun to warm before proceeding with installation. 3. INSTALLATION : BEFORE STARTING , peel back 12″ of the red liner, removing the rest of the liner as you install .