Download 2005 Audi TT Coupe Satellite Radio Receivers Installation – 1. Make sure ignition key is removed. Empty trunk of contents. Move luggage compartment floor assembly by folding forward to allow access to the driver’s side fender panel. 2. Remove the lamp assembly by removing (2) thumb wheel screws. After removal, partially pull the tail lamp assembly straight back. Upon removal, disconnect wiring harness and set lamp assembly aside in a safe location to prevent damage. Note: Placement of thumb wheel screws: White thumb wheel screw is at the top, the black one is inserted at the bottom. 3. With the 8mm wrench, remove the alarm horn from the bracket, disconnect the wire harness, and set the screws and horn aside for re-installation later. 4. With the 10mm wrench or 1/4″ drive ratchet with 10mm universal, remove the first sheet metal screw from the bracket and set it aside. Note: There are two additional fasteners securing the bracket. 5. With the 10mm wrench, remove the second and third 10mm nuts, and set them aside. Remove the bracket from the fenderwell through the tail lamp opening. 6. Locate the SAT wiring harness in the rearfenderwell (taped in foam). Remove the foam, and route through the access panel. Locate the by-pass loop as shown. Remove by-pass loop and discard. 7. Remove ESN ID sticker from the back of satellite radio receiver and attach it to the area shown in the tail lamp access. Remove second label, to be attached to the VAS 5052 print out after completion. 8. Attach satellite radio receiver unit to bracket using 4 threaded clips and mounting screws.